|
12/8/2006 |
Started on canopy rails |
1.0 |
12/27/2006 |
Prep'ed and riveted center canopy rail. Screwed it into place. |
4.0 |
|
12/28/2006 |
Fit canopy frame to fuselage. Cut rails and drilled in position. |
4.0 |
12/29/2006 |
Finished canopy rails. Cut canopy to fit fuselage |
4.5 |
|
12/30/2006 |
Performed The Cut between canopy bubble and wind screen |
2.0 |
12/31/2006 |
Started bonding bubble to frame |
3.5 |
|
1/1/2007 |
Finished bonding canopy bubble to frame |
4.0 |
1/2/2007 |
Cleaned excess SikaFlex |
1.0 |
|
1/3/2007 |
Marked cut lines for right skirt. |
0.5 |
1/4/2007 |
Attached rail block. Drilled holes in canopy frame. |
2.5 |
|
1/5/2007 |
Marked and cut left skirt. |
1.5 |
1/6/2007 |
Drilled left skirt and frame. Trimmed side of glare shield. |
3.5 |
|
1/7/2007 |
Drilled right skirt. Cut to final size. Bonded skirt halves. |
5.5 |
1/8/2007 |
Trimmed more glare shield sides. Built up top sides of skirts. |
3.0 |
|
1/9/2007 |
Finished building up sides of skirts. |
2.5 |
1/10/2007 |
Sanded canopy skirt. Removed mat'l on outside of built up areas. |
2.0 |
|
1/11/2007 |
Primed skirt and painted glare shield. Masked canopy. |
4.0 |
1/12/2007 |
Masked off areas around windscreen for fiberglass. Filled pinholes in
skirt. |
2.0 |
|
1/13/2007 |
Sanded and added more filler to skirt. Bonded windscreen to fuselage. |
5.0 |
1/14/2007 |
More sanding |
2.5 |
|
1/15/2007 |
More sanding and building up |
1.5 |
1/19/2007 |
More sanding and building up |
2.5 |
|
1/20/2007 |
Sanding and building up in back of skirt |
2.0 |
1/22/2007 |
Fiberglasses windscreen frame |
3.5 |
|
1/23/2007 |
More fiberglass around windscreen |
1.5 |
1/24/2007 |
More fiberglass in low spots |
1.5 |
|
1/25/2007 |
Trimmed fiberglass and applied filler |
3.0 |
1/26/2007 |
Sanded around tape. Added thin layer of epoxy |
3.5 |
|
1/27/2007 |
More sanding around tape and another thin layer of epoxy |
3.5 |
1/28/2007 |
Sanded, primed and painted skirt. Bonded and riveted to frame. Another
thin layer of epoxy. |
6.0 |
|
1/29/2007 |
Finished the canopy. Removed tape. |
2.5 |
1/30/2007 |
Misc. rudder pedal work. |
2.5 |
|
1/31/2007 |
Empennage fairing, rear wheel, right brake. |
3.0 |
2/1/2007 |
Left brake line. Bled brakes. |
3.0 |
|
2/3/2007 |
Started trimming top cowl little at a time. |
3.0 |
2/4/2007 |
More top cowl trimming and sanding. |
2.0 |
|
2/5/2007 |
Drilled top cowl to firewall |
2.0 |
2/6/2007 |
Started trimming lower cowl. |
3.5 |
|
2/7/2007 |
More trimming and sanding of lower cowl |
2.0 |
2/8/2007 |
Drilled lower cowl to firewall |
4.0 |
|
2/9/2007 |
Drilled hinges between upper and lower cowl |
3.0 |
2/10/2007 |
Pre'ed and primed hinges. Riveted to firewall and upper cowl. |
5.5 |
|
2/11/2007 |
Riveted hinges to bottom cowl |
2.0 |
2/12/2007 |
Applied a coat of epoxy to fill hole in cowl. |
1.5 |
|
2/14/2007 |
No airplane work on Valentines day (or else) |
0.0 |
2/15/2007 |
Sanded. Applied second coat of epoxy. Installed GPS antenna. |
4.0 |
|
2/24/2007 |
Drilled rudder fairings. Made new remote compass bracket. Primed same. |
4.0 |
2/25/2007 |
Riveted rudder fairings, remote compass bracket. Attached rear seat
belts. |
2.5 |
|
|
|
|
|
|
|
