|
I installed the nutplates for the inner z bracket onto the spar. Then I
bolted all of the z-brackets to the spar and mounted the tank flush
against the spar and leading edge. There was about a 1/16" gap between
the tank and the top inside skin next to the leading edge. It looked
like this was because the flange part of the rib where it gets riveted
to the spar wasn't bent at a 90" angle. I took the tank off, removed the
rib, bent it and put it all back on again. This time it was just about
flush. The joint plate also kept it from being completely flush without
pushing down on it.
I drilled the holes for the attach screws to full size. |
| email: Luis Luciani | Next | Prev | Index | Home |