It would have been a lot better had I remembered to patch it before closing it up. Now I have an outside patch and some drill shavings inside the tank.
|
|
|
I patched the tooling hole in the outside rib. I cut a small plate about
3/4" by 1" and drilled two holes on each side of the hole I was
patching. I loaded it down on both sides with ProSeal and then blind
riveted it into place. Then I globbed on more ProSeal. It would have been a lot better had I remembered to patch it before closing it up. Now I have an outside patch and some drill shavings inside the tank. |
| email: Luis Luciani | Next | Prev | Index | Home |