| Left Wing | |
|
|
|
| 10/23/2005 | Drilled middle ribs. Made holes for conduit and pitot lines. | 2.0 | 10/24/2005 | Etched and Alodined ribs | 2.0 | |
| 10/25/2005 | Primed ribs. Started riveting. | 2.5 | 10/26/2005 | Riveted skeleton. Mounted on wing stand | 2.5 | |
| 10/27/2005 | Cut and drilled wing walk stiffener. Clecoed top skins | 2.5 | 10/28/2005 | Fabricated and mounted tie down bracket. | 3.5 | |
| 10/29/2005 | Mounted leading edge. Finished drilling skins. | 4.5 | 11/14/2005 | Drilled holes for ribs in leading edge | 0.5 | |
| 11/15/2005 | Deburred holes and edges in leading edge skin and ribs | 2.0 | 11/16/2005 | Dimpled all leading edge and rib holes. | 2.0 | |
| 11/17/2005 | Primed leading edge skin. Clecod together | 2.0 | 11/18/2005 | Riveted leading edge | ||
| 11/19/2005 | Worked on landing light | 3.0 | 11/20/2005 | Finished landing light. Riveted leading edge to spar. | 2.5 | |
| 11/21/2005 | Deburred holes for all skins | 2.0 | 11/22/2005 | Primed skins and tanks. Deburred ribs. Dimpled ribs under top inside skin. | 6.0 | |
| 11/23/2005 | Dimpled outside top panel. Riveted inside top panel | 4.0 | 11/25/2005 | Riveted outside top panel. Deburred and dimpled bottom panels. | 3.5 | |
| 11/26/2005 | Riveted aileron hinges together. Pulled conduit. | 1.0 | 11/27/2005 | Aileron gap fairing and flap brace, pitot tube and aligned aileron | 5.0 | |
| 11/29/2005 | Clamped on flap. | 1.0 | 11/30/2005 | Riveted flap to wing. Prepared for skinning. | 2.5 | |
| 12/1/2005 | Started riveting bottom inside panel. | 3.5 | 12/2/2005 | Finished inside panel. 1/3 done with outside one. Riveted and connected pitot tube. | 4.0 | |
| 12/3/2005 | Finished bottom skins. Worked on access plates | 4.5 | 12/4/2005 | Finished access plates. Misc tasks I had postponed until now. | 5.0 | |
|
|
|
email: Luis Luciani