|
10/2/2006 |
Scat tubes behind inst panel and started wiring |
3.0 |
10/3/2006 |
Continued with wiring |
5.0 |
|
10/8/2006 |
Installed ELT antenna. Routed tail wiring through rear bulkheads. |
4.0 |
10/10/2006 |
Secured remote compass. Padded openings in landing gear boxes. |
2.5 |
|
10/11/2006 |
Routed electrical and engine monitor wires through firewall |
2.5 |
10/12/2006 |
Wiring in aft fuselage |
1.0 |
|
10/21/2006 |
Wired remote ELT control, starter switch and added terminal strips for
trim servos. |
3.0 |
10/22/2006 |
Repositioned remote compass sensor. |
3.5 |
|
10/23/2006 |
Wired the rear push to talk and stick and switch panel. |
4.5 |
10/24/2006 |
Ordered radios. Adjusted wiring for rear NAV light. |
2.5 |
|
10/25/2006 |
Cut panel, drilled holes and countersunk for Dynon stack. |
3.0 |
10/27/2006 |
Drove to Conroe and picked up 430, 327 and audio panel. |
|
|
10/28/2006 |
Cutout for AirGizmos and radio stack. |
3.5 |
10/29/2006 |
Made rails for radios and AirGizmos. Installed dimmer PCB. Wired dimmer
and flap switch. |
6.0 |
|
10/30/2006 |
Wired trim LEDs. |
3.5 |
10/31/2006 |
Wired front stick PPT and trim switches |
2.0 |
|
11/1/2006 |
Drew cut lines for DB9 mount |
0.5 |
11/2/2006 |
Wired serial connectors for EFIS and EMS. Wired and powered up EFIS. |
3.5 |
|
11/3/2006 |
Pulled antenna cables. |
1.5 |
11/4/2006 |
Installed COM and transponder antennas. Routed RG-400 for GPS antenna |
6.0 |
|
11/5/2006 |
Installed empennage. Wired and tested tail strobe and NAV light. Riveted
baggage floor. |
5.5 |
11/6/2006 |
Riveted cabin floor. Wired and tested aileron trim and front stick. |
6.0 |
|
11/7/2006 |
Wired elevator trim motor. Tested LED interior lighting. Started
upholstery test. |
4.5 |
11/8/2006 |
Worked on cushion. Primed pax seat back fiberglass. |
4.0 |
|
11/9/2006 |
Cut hole in instrument panel for indicator |
2.0 |
11/10/2006 |
Installed trays and finished with indicator. |
3.0 |
|
11/11/2006 |
Finished trays. Primed panel and seat back. |
3.5 |
11/12/2006 |
Painted interior, rear seat back and panel. Worked on firewall wiring. |
3.0 |
|
11/15/2006 |
Built brackets for rear of radio stack. |
2.5 |
11/20/2006 |
Installed ammeter shunt wires and diplexer. |
1.5 |
|
11/21/2006 |
Remounted DB9's for EFIS and EMS. |
1.5 |
11/28/2006 |
Started wiring GNS-430 to indicator |
2.5 |
|
12/11/2006 |
Installed radio breakers and LEDs |
3.0 |
12/19/2006 |
Installed panel. Powered up radios. |
3.5 |
|
12/21/2006 |
Re-routed GPS antenna cable |
2.0 |
12/22/2006 |
Wired LEDs and pre-wired serial between EFIS/XPDR and EMS/GPS |
4.0 |
|
12/23/2006 |
Installed panel. Hooked up LEDs, supplies and serial busses. |
3.5 |
12/25/2006 |
Hooked up rear headset jacks. Tested radios. |
3.0 |
|
12/26/2006 |
Wired headset jacks, alarms from EFIS and EMS. Tie wrapped loose wiring. |
4.0 |
|
|
|
|
|
|
|
|
|
|
